Emeraude FE

Emeraude FE - SPECIFICATION

Article Index
Emeraude FE
SPECIFICATION
All Pages

SPECIFICATION

  • Discharge air volumes is converted to compressors suction condition (30C)
  • Discharge pressure are measured after the check valve.
  • Service factor (SF) of Main Motor is 1.1. (FE640/770/630H).
  • Noise values are measured in an anechoic chamber at a height of 1 meter and a distance of 1.5m from the front/back and both sides of the package and at full load.
  • Since the cooling for the compressed air & the inside of the compressors unit depends on the surrounding air condition, the surrounding air must be properly ventilated to prevent the ambient temperature from rising above 45C
  • Cooling water temperature should not exceed 32C
  • Please be sure to use the lubricating oil recommended by KOBELCO.
  • Please be sure to use "KOBELCO SUPER GREASE" for greasing motor bearing.
  • Air produced by these compressors should not be used in respiratory equipment furnishing air for direct inhalation.
  • Appearance and specifications are subject to change without notice.
  • Consult us individually, regarding guaranteed performance values.


 

Our Compressors










Our Visitor Counter

TodayToday98
YesterdayYesterday129
This WeekThis Week708
This MonthThis Month1818
All DaysAll Days166433