Kobelion AG/SG

Kobelion AG/SG - SPECIFICATION

Article Index
Kobelion AG/SG
SPECIFICATION
Application
All Pages

STANDARD SPECIFICATION

Air-Cooled Models

Water-Cooled Models

  • Values within brackets [ ] are for H specification models (discharge pressure 0.83 MPa).
  • Discharge air volumes have been converted to compressor intake conditions.
  • Please be sure to use "KOBELCO genuine oil" or the lubricating oil recommended by KOBELCO.
  • Noise values are measured at a height of 1.0 m and at a distance of 1.5 m in all directions from the compressor package in anechoic chamber and under full-loading operation.
  • Values within brackets [ ] are measured at a distance of 1.5 m from the front of the machine of and at a height of 1.0 m of it under full-loading operation.   
  • Air produced by these compressors should not be used in respiratory equipment furnishing air for direct inhalation.
  • Since compressors depend on ambient air for cooling, the installation location must be properly ventilated to prevent ambient temperatures from rising above 40ºC.
  • Specifications and descriptions are subject to change without notice.
  • Service factor(SF) of Main Motor is 1.1.
  • Be aware that a difference in water head level at cooling water inlet and outlet of 15 m or more may cause cooling water to flow too rapidly and cause the tube nest of the heat exchanger to erode. When the difference in water head level exceeds 15 m, adjust the water feed valve to reduce the difference to 15 m or less(10 m or less for AG610W-5/6[H]).
  • Consult us individually,Chinese model.

Air-Cooled Models

Water-Cooled Models

  • Values within brackets [ ] are for H specification models (discharge pressure 0.83 MPa).
  • Discharge air volumes have been converted to compressor intake conditions.
  • Please be sure to use "KOBELCO genuine oil" or the lubricating oil recommended by KOBELCO.
  • Noise values are measured at a height of 1.0 m and at a distance of 1.5 m in all directions from the compressor package in anechoic chamber and under full-loading operation.
  • Values within brackets [ ] are measured at a distance of 1.5 m from the front of the machine of and at a height of 1.0 m of it under full-loading operation.   
  • Air produced by these compressors should not be used in respiratory equipment furnishing air for direct inhalation.
  • Since compressors depend on ambient air for cooling, the installation location must be properly ventilated to prevent ambient temperatures from rising above 40ºC.
  • Specifications and descriptions are subject to change without notice.
  • Service factor(SF) of Main Motor is 1.1.
  • Be aware that a difference in water head level at cooling water inlet and outlet of 15 m or more may cause cooling water to flow too rapidly and cause the tube nest of the heat exchanger to erode. When the difference in water head level exceeds 15 m, adjust the water feed valve to reduce the difference to 15 m or less(10 m or less for SG610W-5/6[H]).
  • Consult us individually,Chinese model.
 
  



 

Our Compressors










Our Visitor Counter

mod_vvisit_countermod_vvisit_countermod_vvisit_countermod_vvisit_countermod_vvisit_countermod_vvisit_counter
mod_vvisit_counterToday14
mod_vvisit_counterYesterday0
mod_vvisit_counterThis Week14
mod_vvisit_counterLast week0
mod_vvisit_counterThis Month14
mod_vvisit_counterLast month0
mod_vvisit_counterAll Days257403

We have: 14 guests online
Your IP: : 54.198.212.30
 , 
Today: October 23, 2018